JP SERIES, 10 THRU 30 GPM
 

Print  print

Performance

Accessories

BETTER PRESSURE!!!

The PENTEK INTELLIDRIVETM Water Pressure Control Center automatically adjusts motor speeds to meet changes in water demand. Instantaneous feedback from an electronic pressure transducer instructs the drive to change the submersible well pump motor speed to maintain constant pressure throughout the system.

Product Images

CSA ApprovedCertified NSF ANSI 61
Model JP Series, 10 thru 30 GPM
4" Submersibles, Composite Materials, 1/2 thru 1-1/2 HP, 2- and 3-Wire, 10 - 30 GPM, 1-1/4" discharge

Precision-engineered, corrosion-resistant composite pumps deliver efficient, dependable performance even in rough, aggressive water

Key features
  • SignaSeal™ staging system incorporates a harder-than-sand ceramic wear surface and a floating impeller design - which together literally pulverize sand and small debris. This proven feature reduces lock-ups, dry-runs, and abrasive wear.
  • Floating Stage Design is engineered to transmit forces away from the motor bearing and through the pump housing. This reduces premature wear and misalignment.
  • Fully-Enclosed Shaft Bearing creates a pressure zone that prevents sand & water from entering. Eliminates wear and misalignment.
  • Wear Ring forms a seal between impeller hub and suction cap for low friction and no unwanted recirculation of water.
  • Corrosion-resistant fiberglass reinforced thermoplastic intake & discharge for durability in aggressive water.
  • Large octagon wrench area for ease of installation.
Warranty

1-year limited warranty

SPECIFICATIONS    
RESOURCES    

 

HORSEPOWER:  Available in 1/2 thru 1-1/2 HP

PERFORMANCE SERIES:  10, 15, 20, and 30 GPM Series Available

NUMBER OF STAGES:  5 - 14 (model dependent)

VOLTAGE:  115v (1/2 HP only) or 230v, 60 Hz

NUMBER OF WIRES:  2-or 3-wires plus ground (model dependent)

MATERIALS:  Corrosion Resistant fiberglass reinforced thermoplastic

SHELL:  Stainless steel

DIAMETER:  3-3/4"

LENGTH:  22-1/4" to 34-3/4" (model dependent)

WEIGHT:  27" to 43"

DISCHARGE:  Fiberglass-Reinforced Thermoplastic, 1-1/4" NPT

DISCHARGE BEARING:  Self-Lubricating Nylatron®

IMPELLERS:  Acetal

DIFFUSERS:  Polycarbonate

SUCTION CAPS:  Polycarbonate with Stainless Steel Insert

THRUST PADS:  Proprietary spec

SHAFT END COUPLING:  Stainles Ssteel

INTAKE:  Fiberglass-Reinforced Thermoplastic

INTAKE SCREEN:  Polypropylene

CABLE GUARD:  Stainless steel

CHECK VALVE:  Acetal

:  

:  . . . . Nylatron® is a registered trademark of Quadrant Engineering Plastic Products

Owner's Manual: Signature 2000 4" (1/2 HP - 10 HP)
DOWNLOAD MANUAL
Specifications: JP (10 to 30 GPM)
DOWNLOAD SPECS
Selection Guide: 4" Submersible Cable
DOWNLOAD GUIDE